So, Zo... Strappy Vest Top V

Velvet and bodysuits definitely feature in my top 10 sexiest things (right next to bob haircuts and David Gandy in that Dolce and Gabana advert), so it seemed like a natural pairing to use this black velvet from Minerva alongside the bodysuit pattern hack I'd been working on, using the So Zo free vest top and Simplicty 8513 bodysuit patterns as a base. 

This fabric is a cushed velvet which catches the light from all angles. What I really like about this velvet, is it doesn't instantly get my heckles up if I stroke it the wrong way 😅 Don't get me wrong, there is a clear nap to it, but it's very comfortable to wear. 

The fabric is described as 80% stretch crossways and 10% stretch lengthways. I must admit when the fabric arrived and I did a test stretch, the lengthway stretch felt pretty non existent (Have I overestimated what 10% stretch feels like?). The alarm bells were already going off that a fabric with only 2 way stretch was probably not going to work for a bodysuit. The Simplicity 8513 bodysuit pattern however did say that it was suitable for 2 way stretch on the packet (spoiler; it's not) so I thought I would cut it out anyway, with the option of cropping the 'leg' area off if needed and therefore elimiating the necessity for lengthway stretch. 

With this issue in mind, I did cut the body pieces out with a couple of extra cms in the length (hmmm, not enough). 

I was excited to try my new little hack to this pattern by inserting a powermesh panel into the front section. I drew out on my pattern piece the depth of the triange I wanted and then added a 1cm seam allowance to both the new neck opening and the edge of the triangle. I fiddled around a bit then trying to remember how to line up the triangle and exactly where to clip to at the V-point so the triangle sat flat. Any creeping seam allowances here were put in their place by using a straight stitch and topstitching around the panel. 

I used a lovely picot edge elastic around the back/underarm/front neck and attached pre-made straps pinched off of a Primark Bra (sometimes a lot cheaper to buy and deconstruct than it is to buy supplies from scratch). I hand stitched the straps at the front for an invisible join and also cause the fabric gets a bit bulkly there where the elastics all meet. 

With straps on, I could try on the bodysuit. I attempted pinning at the crotch to see what comfortable range of motion I had. The front looked OK, though a lot shorter than I would wear my bodysuits. The back however was pulling at my hips, meaning the fabric wasnt fitting to my lower back, the curve in the centreback was too high as the fabric wasn't stretching the way it would with 4 way stretch. My mind was made up to convert to vest top, but I did get some photos of the garment as a proposed bodysuit to remind myself I was right - this pattern and velvet was definitley scoring the sexy points. 

I tried on once I'd removed the bottom part of the pattern and felt the vest top would benefit from a slightly curved hem. I chalked the curve onto the velvet following the natural contours of my body, making sure both sides were symmentrical when I snipped away the excess. I added a cute trim of picot elastic to finish the bottom edge and we were good to go! 

I love the velvet and the mesh working together, and I think the velvet is super flattering. Looking forward ot having a go at the full bodysuit version when I get my hands on something with a little more stretch. 

x

Location: Home Sweet Home

Currently Listening to: A Pile Ou Face, Felipecha